Contact me

Wednesday, May 10, 2017

Purple and gold for a get well card


I worked on a few get well cards and this one was my last one for now.  I started with the laser printed decorative paper which I ripped in two, trimmed to fit above and below the embossed border that I added to my purple layer and then glued into place.  I added a length of vintage seam binding gluing the ends to the back of the layer before adhering this large element to the front of a gold card.  I punched a purple scallop circle (SU) and added a round greeting punchie (DesertDiva) which I had watercoloured to coordinate.  I pierced each scallop to add a bit of texture before I adhered it to my card front using 3D foam tape.  I tied a short length of seam binding to the one on the front of my card with a single knot to simulate a bow.  I love this colour combination!!  Bright and cheery!

Therese

Red and orange with a round Get well greeting

I made another get well card for my stash.   I started with a scrap of decorative paper I had on my desk which featured oranges and reds.  Check out the cards I made with the other piece of this rainbow paper.   I found an embossing folder that coordinated nicely and embossed the top portion of a orangy rust card and adhered my decorative paper to the bottom portion.  I layered a laser printed round greeting (CLKER) with a watercoloured border onto a red scalloped circle and added a yellow silk flower, a yellow sequin and attached them all together using a tiny gold.  I pierced each scallop to add a bit of texture to this focal element.  It needed a bit of something to finish it off so I die cut this swirl and glued the ends to the back of my focal element before adding it to my card front.
I really like the colours and it makes a very nice bright get well card.

Therese