Contact me

Tuesday, January 16, 2018

White embossing on watercolour paper - bright cheery cards!


These two cards were made up from kits I found on my desk from this class.  I love these!!!  I simply added watercolour until I was happy with how they looked and left them to dry.  For the left hand card I stamped and clear embossed a friendship quote (SU) in the center section of the background and then added three flower sequins in coordinating colours using tiny brads.  This focal element was layered onto coordinating cardstock and then onto a black card front.  For the right hand card I added a coordinating organza ribbon and tied a short end to the bottom section to simulate a bow before adding a laser printed chalkboard greeting over it using 3D foam tape.  I glued this layer to a coordinating cardstock and then onto a black card front.   I have a few more kits from this class so expect to see them in the next little while!!  I really fun technique!!  Therese

More monochromatic cards using a coordinating set of papers - birthday and sympathy

I have been working on getting a few more of these cards made up. Check out the first set here. I cut up the first sheet of paper by cutting out all the large floral elements on the sheet.  I layered them all onto deep maroon cardstock to create my focal elements.
For the top card I used an oval focal element which was created using Nestibilities.  I added a single layer on the maroon card front and stamped a greeting. Unfortunately, it was the wrong colour and crooked so I trimmed off the bottom edge of the paper and replaced it with a piece from the original sheet and added a strip of maroon cardstock over the joint.  I added an organza ribbon with a simulate bow and then mounted my oval focal element over it using 3D foam tape.  I added a layered punchie greeting on the lower right hand corner.

For the second card I used the same background paper and added organza ribbon as well.  I punched a slot in the spine of the card so I could insert the end of my ribbon and glued the end to the inside front of my card with double sided tape.  Tied on a short piece to simulate a bow on this one as well.  Added my rectangular focal element over the ribbon using 3D foam tape and adhered the layered punchie greeting using double sided tape.
It has been a fun challenge to create cards with this set of papers. 
Therese       

Christmas cards with non traditional colours - red, black, green and gold















My first Christmas cards of the year!!  I made these for a friend of mine who had a small piece of this gorgeous green paper with gold trees on it that was wrapped around one of her Christmas gifts.  I offered to make her some Christmas cards for next year with it!!  The trees were different sizes hence the different size of ovals on these cards.  I used my oval Nestibilities to figure out which ones would be good for card avoiding any of the folded or rough spots that had been on the corners.  I traced around the die and then cut them out with scissors  giving each one enough edge so they could be glued behind the ovals.  These are a bit smaller than A2 so I had to be really diligent when cutting my pieces because they all had to be just a bit smaller.   I gold embossed my greetings (SU) on the black layer, die cut the ovals and then glued the trees to the back of the opening after lining them up.  Finally I glued these large elements to the front of cranberry cardstock cards.  They are quite striking and not typical Christmas cards.  I have yet to make any for myself but it is in the works!!  Therese