Contact me

Wednesday, September 04, 2019

Birthday card featuring a dimensional sticker, ribbon and decorative paper

Our god daughter's birthday is coming up soon and I made this card for her!!  I started with a large envelope and made a soft peach card to fit inside.  I added two strips of white embossed cardstock on the top and bottom.  For the middle section I trimmed a piece of laser printed decorative paper into three.  I added two strips of aqua to my card front and then glued the three pieces of decorative paper into place overlapping the aqua strips.  For my focal element I started with a small dimensional sticker.  I added layers - peach, embossed aqua - peach and then onto a larger brown rectangle gluing them together as I went. I used my distress tool on the edges of  the brown one and then added flagged ribbons to the backside of it on the top right and lower left.  As I was considering where to place my focal element I decided I needed a bit more texture so I ran my tracing wheel over the two aqua strips on my card and used a brown gel pen to add a line to my two white embossed strips.  That was better!!  I used 3D foam tape to add my focal element to my card.  Pretty happy with how it turned out!!          Therese

Felted wool dryer balls - part one

 I have been thinking about making dryer balls for a while using the scraps of wool I have stashed!! I found this tutorial on The Spruce which uses hot water in a pot on the stove instead of a hot water wash in my washing machine which seemed a better use of water.  So I got started and found some felted wool scraps for my center.

I wrapped some felted wool around it to start creating a ball and then wrapped a long scrap of felted wool around and it started looking more like a ball.  I dug through my unfelted wool stash and found this pale pink cashmere sweater which had already been cut up for another project and cut some half inch strips from two of the panels.  I started wrapping the unfelted wool strips around my ball and just kept adding strips until it was the size of a hard baseball.

 I decided to tie yarn around it to keep it all together until I could get a few more made.  I managed to make two more balls and they are ready for felting.  I will continue with the felting instructions when I get to them.  
Therese