My final kit from
this class. I trimmed my decorative paper but failed to remember that the cuts had to go from side to side to get the spacing in needed so I ended up with a few more cuts to get the spacing to work. I glued the pieces to the green layer and then added a length of ribbon which ran through the intersection of the pieces gluing both ends to the back using double sided tape then tied a short piece onto it using a single knot to simulate a bow. I adhered this large element to a blue card front and then added my layered laser printed greeting which I had embellished with watercolour over the ribbon using 3D foam tape. The "bow" slides so you can put it anywhere you need it on the length to which you have tied it. Therese
