This card features a reused card panel, a floral focal element, some texture from a tracing wheel and some ribbon

Another card for my stash!!
For this card I reused a card front with a small rose image.  I die cut the rose image out of the panel using two Nestibilities circle dies nested in each other  It produced a circle element, a ring and a large opening in the panel.  FUN!!!  I layered the rose image onto a white scalloped circle (SU) and pierced each scallop with a push pin.  I mounted the panel with the opening onto a green layer, punched the right hand side with the eyelet border punch (SU) and added a couple rows of texture in between using my tracing wheel.  The panel looked a bit plain so I added some tracing wheel lines on it as well.  Much better!!  I added a length of ribbon which coordinated with the little flower next to the rose and adhered both ends to the back of the layer.  I tied a short length to it using one knot to simulate a bow.  I mounted this large element to a pink card front, adhered my focal element into the opening and mounted my little laser printed greeting using 3D foam tape just above the ribbon on the right hand side.   Therese