Saturday, February 29, 2020

Birthday card from a kit featuring a butterfly kisses image, embossed strip and decorative background paper

For this card I started with a card kit from September's class.  I decided to trim out the circle because it was already folded and used a different image as well to accommodate the trimmed piece.  I trimmed the butterfly kisses (Melonheadz), layered it with aqua and then trimmed the dark purple to size leaving a bit at the bottom which I trimmed with decorative scallop scissors.  I watercoloured the image, added clear glitter to the wings before gluing all the layers together and added dots of clear glitter to the scallops.  I layered a strip of aqua over a strip of orange and then embossed them with a chevron embossing folder.  I adhered my trimmed background to my dark green card front, added the embossed strip and then mounted my layered image over the strip using 3D foam tape.  Really happy with how this one turned out and I will be using that embossing folder again for strips - lots of nice texture and some direction as well. 

Therese

Slow Stitching - #2 tree

I have finished my second tree square in my current Slow Stitching project.  I am really happy with how these are working out!!  I first pinned the two halves to my blue square and used cross stitches in deep pink to secure them both to the background.  Next, I stitched up the right side with vertical stitching.  I did horizontal stitching on the left hand side.  I did my best to capture the edges while I was stitching which gives them a bit of a different look than the other squares I made.   I added a star to this tree as well but it is not much more of an improvement on the first one I did.  I will have to check my embroidery book and see what I am doing wrong as I am sure there are some that look better than that.  I also added french knots in yellow thread over all of it!!  Therese

Birthday card featuring glittered flowers, handcut stems, embossed oval and a small greeting

This kit is one from my January cardmaking class.  I am making them up to build up my stash of ready made cards.  I am changing up a few of the elements as I go because too much of the same does not work really well for me.  For this card, I adhered the stamped, embossed and watercoloured resist background to a coordinating card front.  I embossed the oval with a Swiss Dot embossing folder and adhered it to my card front.  I hand cut some leaves and stems, embossed them and then glued them to my oval.  I added the flowers using 3D foam tape after trimming the stems to a proper length.  I tucked the little greeting from the kit into the leaves and used a small piece of 3d foam tape to the end which I flagged.  I really like this one!!

Therese

Sympathy card from a kit featuring a watercoloured floral image, a layered punchie greeting and an embossed circle

I found another few kits when I was cleaning up my desk and because of the pieces I decided to make up the cards because there was not too much flexibility in the pieces without a bit of a redo of most of them.  They are from my September card making class.
To change it up a bit I trimmed the large circle and embossed it with a soft swirl embossing folder.  I adhered the background paper (stamped decorative paper) and the circle to the purple card front.  I trimmed the image into a rectangle and punched the corners using a little corner punch.  I found this fiber in my stash and ran it around the image and tied it off at the top.  I mounted this focal element to my card overlapping the circle using 3D foam tape.  I had punched a scallop oval out of the circle before adhering it to my card.  I used it to layer the font sympathy greeting which I sponged with a bit of green before layering them.  I mounted the greeting with double sided tape on the top portion and 3D foam tape on the bottom.             Therese