Exchange card featuring masterboard background, embossed die cut butterfly and a little font greeting

Here is the first card I made with the masterboard I created a few days ago.  I trimmed the masterboard into 6 pieces and cut a blue layer of cardstock the same size as one of the pieces.  I laid them onto each other and aligned them over the butterfly on my large Sizzix die and to avoid cutting off pieces due to the proximity of the other dies I carefully positioned my small cutting plate (broken pieces) over the area I wanted to cut.  I did get a tiny cut on the lower left hand side which is covered by the greeting on my card.  I embossed the blue butterfly for this card and then added a black die cut body (on the same die) which I trimmed to the perforated edge.  I placed the butterfly into the opening of the masterboard piece and used regular tape to adhere the body of the butterfly to the back of the master board layer which allows the wings to be raised a bit to add dimension.  I decided to use a large envelope and made a kraft card to fit inside.  I added a blue colour printed background which had previously been stamped with a random texture background in a light green which worked very well with this focal element.  After adhering the background to my card front I added a strip of green cardstock to which I had added a length of narrow black ribbon gluing the ends to the back of the layer before adhering to my card front.  I auditioned my butterfly element and decided to add black to the edges to help frame it.  I ran a black permanent marker on all the edges.  That was much better!  I adhered this large element to my card front using 3D foam tape.  Finally, I added a small rectangular font greeting in blue to the bottom right corner.  I flagged the right hand edge and added three little dots with a black permanent marker on the left hand edge.  I like the way this one turned out.  One of my exchange cards ready to go!!

Therese