Shirt savers - special request

 I have been working on a special request - six adult shirt savers!!  A friend and I committed to making a dozen of these before the fabric sale and decided with that commitment over we would get started.  I had made one of these for Dad when he went into care and had a pattern already worked up after some internet research to establish a size - approximately 36" x 18".  

I had to modify my pattern a little bit because the request specified a soft closure rather than a mechanical one (velcro, snaps, etc).  After a bit of research and some inquiries to some who work in the industry we were able to get a visual of the sort of closure that they had requested.  It entails pulling one of the ends through a hole in the other piece and folding it over to keep the shirt saver on.  It gives a very quick release as well when removing and nothing to worry about when they are sent off to the laundry.  I made up a couple patterns and my partner and I got started.  I passed on the cotton and flannel we had set aside as there was only enough to make six of them.  I dug through my stash of fabric and came up with several different pieces of cotton and a large piece of flannel.  Fortunately, there was a smaller scrap of flannel in what we had picked out and I was able to get another piece from the end of the large one we had set aside.  The piece I had made four so I was good to go!!!  I had cut all six out last week and was able to get all the sewing done today!!  We decided to sew the cotton and flannel with good sides together and leave an opening so we could turn the whole thing inside out.  I added two rows of stitching all the way around and then cut a slot (1.25") in one of the sides to which I added a length of seam binding.  I then stitched the two sides to each other before finishing off the edge with another length of seam binding.  It makes a neat finish and easily identifies where the slot is.  I had cut a 1.5" slot in my prototype but it was made out of different fabric and three layers.  I decided to start with 1.25" because these were lighter and I am glad I did.  I put the cotton on the front and flannel on the back but really these are reversible and can be used with either side to the front and with the colours I chose should be gender neutral on at least one side.  I hope the person we made them for will be happy with our efforts and I am sure they will be put to good use!!!  Therese